F 350 2WD Super Duty V8-5.4L (2008)
3. Position the intake manifold vacuum tube assembly onto the support bracket and the valve cover stud.
4. Connect the VCT solenoid electrical connector and the wiring harness retainers.
5. Connect the radio ignition interference capacitor electrical connector.
6. Connect the intake manifold vacuum tube hose to the brake booster.
7. NOTE: Verify that the ignition coil spring is correctly located inside the ignition coil boot and that there is no damage to the tip of the boot.
Install the 4 LH ignition coils and the 4 bolts.
^
Apply a light coat of dielectric compound to the inside of the ignition coil boots prior to installation.
^
Tighten to 6 Nm (53 lb-inch).
8. Connect the 4 LH ignition coil electrical connectors.
9. Position the 2 EVAP system tubes and connect the quick connect couplings.
10. Install the oil level indicator and tube.
11. Position the PCV tube and connect the quick connect couplings.
12. Connect the degas bottle coolant outlet hose.
13. Install the degas bottle assembly.
14. Install the air cleaner outlet pipe.
