F 350 2WD Super Duty V8-5.4L (2008)
3. Connect the wiring harness retainers to the valve cover.
4. Connect the VCT solenoid electrical connector.
5. NOTE: Verify that the ignition coil spring is correctly located inside the ignition coil boot and that there is no damage to the tip of the boot.
Install the 4 RH ignition coils and the 4 bolts.
^
Apply a light coat of dielectric compound to the inside of the ignition coil boots prior to installation.
^
Tighten to 6 Nm (53 lb-inch).
6. Connect the 4 RH ignition coil electrical connectors.
7. Connect the 2 PCM electrical connectors and the wiring harness retainers to the support bracket.
8. Position the crankcase vent tube and connect the quick connect couplings.
9. Connect the heater coolant hose to the engine coolant crossover manifold assembly.
10. Position the transmission filler tube and install the bolt.
^
Tighten to 10 Nm (89 lb-inch).
11. Fill and bleed the engine cooling system.
