F 350 2WD Super Duty V8-5.4L VIN 5 (2006)
11. Disconnect the 8 fuel injector electrical connectors.
12. Remove the 8 fuel injector-to-fuel rail locking clips.
13. NOTE: When removing the fuel rail, leave the fuel injectors in the intake manifold. This will make removal of the fuel rail easier.
Remove the 4 fuel rail bolts and the fuel rail.
-
To install, tighten to 10 Nm (89 lb-in).
14. CAUTION: Use O-ring seals that are made of special fuel-resistant material. Use of ordinary O-rings can cause the fuel system to leak.
Do not reuse the O-ring seals. Lubricate the O-ring seals with clean engine oil prior to installation.
Remove the fuel injectors and the fuel injector O-ring seals.
-
Discard the O-ring seals.
15. To install, reverse the removal procedure.
