F 350 2WD Super Duty V8-6.4L DSL Turbo (2009)
11. NOTICE: Only use hand tools when installing the engine mount retaining nuts or damage to the engine mount may occur.
Install the 4 new RH engine mount retaining nuts.
-
Tighten to 115 Nm (85 lb-ft).
12. Position the RH turbocharger inlet pipe in the vehicle.
13. NOTICE: Failure to correctly install the high-pressure fuel injection pump heat shield may result in engine damage.
NOTE: High-pressure fuel injection pump heat shield removed for clarity.
Install the high-pressure fuel injection pump heat shield in the vehicle and install the 2 center bolts.
-
Tighten to 13 Nm (115 lb-in).
14. NOTE: Engine removed from the vehicle for clarity.
Position the fuel tube bracket and ground strap. Install the 5 retaining nuts and bolt for the high-pressure fuel injection pump heat shield.
-
Tighten the fuel line bracket nuts to 7 Nm (62 lb-in).
-
Tighten the remaining fasteners to 13 Nm (115 lb-in).
