F 350 4WD Pickup V8-7.3L DSL Turbo VIN F (1994)
9. Disconnect the vent tube at the axle housing. Plug the vent fitting.
10. On the right-hand side of the vehicle, remove the nut and bolt, and disconnect the tracking bar from the right-hand spring cap.
11. Carefully lower the twin-post hoist until the vehicle is approximately three feet from the floor.
WARNING: BEFORE PROCEEDING, MAKE SURE THE VEHICLE IS SECURELY SUPPORTED.
12. Position safety stands on the front coil springs (5310) about halfway between the front coil spring and the rear mounting shackle. Lower the
vehicle so the front springs rest on the safety stands.
13. Support the axle under the differential carrier with a suitable jack, such as Rotunda Heavy Duty Truck Transmission Jack 077-00008 or
equivalent.
14. Remove the U-bolts and nuts securing the axle to the spring.
15. Carefully lower the axle from the vehicle.
16. If required, place the axle in a suitable differential carrier repair stand.
INSTALLATION
