F 350 4WD Super Duty V10-6.8L VIN Y (2006)
2. Position the RH valve cover and new gasket on the cylinder head and tighten the 16 fasteners in the sequence shown
^
Tighten to 10 Nm (89 inch lbs.).
3. Lower the engine into position.
4. CAUTION: Only use hand tools when installing the RH engine mount nut or damage to the engine mount can occur.
NOTE: RH shown, LH similar.
Install the 6 engine mount nuts.
^
Tighten to 103 Nm (76 ft. lbs.).
5. Position the Y-pipe and install the 4 nuts.
^
Tighten to 40 Nm (30 ft. lbs.).
