F 350 4WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
Driver seat only
3. Disconnect the safety belt buckle warning indicator switch electrical connector and separate it from the mounting bracket.
4. Pull the wire harness and electrical connector through the seat.
INSTALLATION
All vehicles
1. NOTE: Make sure to tighten all nuts and bolts to specification.
To install, reverse the removal procedure.
2. Check the active restraint system for correct operation.
Rear, SuperCab
SAFETY BELT BUCKLE - REAR, SUPERCAB
Torx Bit, Safety Belt Bolt
SPECIAL TOOL(S)
REMOVAL
NOTE:
-
New safety belt buckles, height adjusters, center adjust tongues and belts and retractors can be installed separately. However, if a safety belt
assembly was in use during a collision, a new belt and retractor must be installed as well as the center adjust tongue and belt and buckle assembly,
or the center adjust tongue and the cable and buckle assembly. When installing new safety belts and buckles, height adjusters, safety cables and