F 450 2WD Super Duty V10-6.8L VIN S (1999)
2. Install the Torque Converter Leak Check Tool and Gasket into the converter hub.
3. WARNING: ALWAYS FOLLOW PROPER SAFETY PROCEDURES WHILE USING THE PRESS.
Install the Converter Assy. with the installed leak check tool into the Arbor press.
Secure the press. Apply enough force from the press to seal the tool into the Converter Assy.
4. NOTE: Use clean, dry shop air.
Apply air pressure to the valve on the leak check tool.
5. With air pressure applied to the valve, inspect for leaks at the converter hub, the seams and the studs. A soap bubble solution can be applied
around those areas to aid in the diagnosis. If any leaks are present, replace the converter.
6. Remove the air hose. Release the pressure, and then slowly release the press. Remove the converter. Remove the tool.
