F 450 2WD Super Duty V8-6.4L DSL Turbo (2008)
23. NOTE: Only one glow plug connector shown.
Install the glow plug harness and connect the retainers.
-
Make sure the seals are securely seated in the valve cover.
24. Position the engine wiring harness back. Connect the glow plug electrical connector and the wire retainer.
25. Install the glow plug module bracket and the bolts.
-
Tighten to 13 Nm (115 lb-in).
26. Position back the engine wiring harness. Install the bolt for the engine wiring harness.
-
Tighten to 13 Nm (115 lb-in).
27. Connect the pushpin retainer to the glow plug module bracket.
28. Attach the electrical connector retainers. Connect the glow plug module and fuel injection pump electrical connectors.
29. Connect the EGRT sensor electrical connector.
30. Position the glow plug module heat shield and install the 3 pushnuts.
