F 450 4WD Super Duty V8-6.4L DSL Turbo (2008)
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Disconnect the battery ground cable. For additional information, refer to Battery.
3. Drain the engine cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding.
4. Recover the A/C system. For additional information, refer to Heating and Air Conditioning.
5. Loosen the clamp and disconnect the LH charge air cooler (CAC) tube from the CAC.
^
To install, tighten to 12 Nm (9 lb-ft).
6. Remove the bolt and position the hood latch lever in front of the cooling module.
^
To install, tighten to 13 Nm (10 lb-ft).
7. Disconnect the horn electrical connector.
8. If equipped, detach the fog light electrical connector retainer from the headlamp housing.
9. Loosen the clamps and disconnect the RH CAC tube from the CAC and the turbocharger.
^
To install, tighten to 12 Nm (9 lb-ft).
10. NOTE: The fuel cooler radiator side bolt does not have to be removed to remove the fuel cooler radiator.
