F 450 4WD Super Duty V8-6.4L DSL Turbo (2008)
35. Install the special tool on the front end accessory drive (FEAD) bracket.
36. NOTICE: Use a lifting crane and load leveler rated at a minimum of 907 kg (2,000 lb) or damage to the vehicle may occur.
Position the heavy duty lifting crane with a commercially available load leveler and attach the chains to the front of the engine.
37. NOTE: If the engine or body is raised too quickly, you will not get the lift required to remove the oil pan. Check the height several times while
lifting.
With the help of an assistant, lift the engine and raise the body 101.6 mm (4 in) at the same time. Check the clearance between the cab mount and
the body.
38. Support the engine with jackstands or other suitable support devices.
39. Remove the remaining oil pan bolts and position the oil pan to access the oil pick up tube bolts.
40. Remove the bolts for the oil pick up tube and place the tube in the oil pan. Remove the oil pan.
^
Remove and discard the oil pick up tube O-ring seal.
41. Remove and discard the press-in-place gasket.
Installation
All vehicles
1. Install a new press-in-place gasket for the oil pan.
2. NOTE: Install a new O-ring seal on the oil pick up tube and place the tube in the oil pan.
Position the oil pan and install the pickup tube.
^
Tighten to 13 Nm (115 lb-in).
