Festiva L4-81 1.3L SOHC EFI (1989)
20.
Place hub/rotor assembly into steering knuckle bore, then press assembly fully into knuckle using suitable tools.
21.
Follow steps 1 through 7 in reverse order to complete installation and note the following:
a. Apply a thin coat of grease to halfshaft splines before installing steering knuckle and hub/rotor assembly.
b. When installing new halfshaft attaching nut, apply brakes to prevent hub assembly from turning. Stake nut into groove on halfshaft after
tightening.
c. Tighten tie rod end to steering knuckle attaching nut, then install new cotter pin. If holes in attaching nut do not line up with hole in ball
stud, tighten nut as required until cotter pin can be installed. Never loosen nut when installing cotter pin.
