ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Fuel Injectors - 1.6L > < Throttle Body - 1.6L

Fiesta 1996 (08.1995-02.2002)

Fuel Charging and Controls - 1.25L/1.4L Zetec-SE (Sigma)/1.6L - Throttle Body—Vehicles Built From: 02/2000 1.25L Fiesta 1996 (08/1995-02/2002)
Removal and Installation

Removal
  1. CAUTION:
    CAUTION:Do not attempt to clean the throttle body. The bore and the throttle plate have a special coating applied during manufacture which should not be removed.
    Disconnect the air cleaner outlet pipe.

  1. Disconnect the throttle position (TP) sensor electrical connector.

  1. Remove the air cleaner cover.
    1. Detach the positive crankcase ventilation (PCV) hose.
    1. Remove the air cleaner cover.

  1. Detach the throttle body.

  1. Remove the throttle body.
    1. Disconnect the accelerator cable.
    1. Remove the throttle body.

  1. Remove and discard the gasket.

Installation
  1. CAUTION:
    CAUTION:Do not attempt to clean the throttle body. The bore and the throttle plate have a special coating applied during manufacture which should not be removed.
    NOTE:
    NOTE:Install a new gasket.
    NOTE:
    NOTE:Make sure the throttle body tightening sequence is followed correctly.
    To install, reverse the removal procedure.

Fuel Injectors - 1.6L > < Throttle Body - 1.6L