ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
High-Pressure Cutoff Switch > < Evaporator Core Orifice

Fiesta 2002.25 (11.2001-)

Air Conditioning - Low-Pressure Cutoff Switch Fiesta 2002.25 (11/2001-)
Removal and Installation

Removal

  1. Remove the right-hand headlamp.
    For additional information, refer to: Headlamp Assembly (417-01 Exterior Lighting, Removal and Installation).

  1. Disconnect the low pressure switch connector.

  1. WARNING:
    WARNING:Make certain that the valve of the low pressure switch is completely closed after removal of the low pressure switch, to prevent refrigerant from escaping. Failure to observe this instruction can lead to injury.
    Remove the low pressure switch.
    • Discard the O-rings.

Installation

  1. NOTE:
    NOTE:Install new O-rings on the low pressure switch.
    NOTE:
    NOTE:Coat the low pressure switch O-rings with clean refrigerant oil before installation.
    Reinstall the components in reverse order.

High-Pressure Cutoff Switch > < Evaporator Core Orifice