ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Footwell Vent-Duct Blend Door Actuator > < Air Inlet Blend Door Actuator

Fiesta 2002.25 (11.2001-)

Control Components - Temperature Blend Door Actuator Fiesta 2002.25 (11/2001-)
Removal and Installation

Removal

Left-hand drive vehicles.
  1. Remove the glove compartment.
RHD vehicles
  1. Open the stowage space and remove the screws for the dashboard lower trim.

  1. Detach the dashboard lower trim from the dashboard.
All vehicles
  1. Detach the centre console side trim on the right-hand side.

  1. Remove the temperature control flap actuator.
    1. Disconnect the electrical connector of the temperature control flap actuator.
    1. Remove the screws.
    1. Pull off the temperature control flap actuator from the flap shaft.

Installation

  1. NOTE:
    NOTE:During installation of the temperature control flap actuator, ensure that the end positions of both toothed segments are correctly positioned in relation to each other.
    NOTE:
    NOTE:After installing the temperature control flap actuator, initialize the temperature control flap actuator using the air conditioning system control panel. To do this, press the "Footwell" and "OFF" buttons simultaneously, then press the "Auto" button.
    To install, reverse the removal procedure.

Footwell Vent-Duct Blend Door Actuator > < Air Inlet Blend Door Actuator