| Removal and Installation Removal CAUTION:When removing or installing the instrument panel, care must be taken not to scratch or damage the instrument panel surface. | | -
Remove the passenger air bag module.
For additional information, refer to: Passenger Air Bag Module - Vehicles Built Up To: 10/2005 (501-20B Supplemental Restraint System, Removal and Installation).
| | | -
Remove the floor console.
For additional information, refer to: Floor Console (501-12 Instrument Panel and Console, Removal and Installation).
| | | -
Remove the steering column.
For additional information, refer to: Steering Column (211-04 Steering Column, Removal and Installation).
| | | -
Remove the audio unit.
For additional information, refer to: Audio Unit - Vehicles Built Up To: 10/2005 (415-01 Audio Unit, Removal and Installation).
| | | -
Remove the instrument cluster.
For additional information, refer to: Instrument Cluster - Vehicles Built Up To: 10/2005 (413-01 Instrument Cluster, Removal and Installation).
| | | -
Remove the A-pillar trim panels. | | | -
Detach the data link connector (DLC) from the driver side lower instrument panel. | | | -
Detach the hazard warning control switch from the instrument panel. | | | -
Disconnect the electrical connector and remove the hazard warning control switch. | | | -
Detach the liftgate remote release control switch from the instrument panel. | | | -
Disconnect the electrical connector and remove the liftgate remote release control switch. | | | -
Detach the passenger air bag deactivation (PAD) switch from the instrument panel (if equipped). | | | -
Disconnect the electrical connector and remove the passenger air bag deactivation (PAD) switch (if equipped). | | | -
Remove the instrument panel outer side trim panels. | | | -
Remove the instrument panel inner side trim panels. | | | -
Remove the instrument panel outer retaining screws and nut (left-hand side shown). | | | -
Remove the instrument panel center retaining nuts. | | | -
Remove the audio unit support bracket. | | | -
Detach the glove compartment striker from the cross-vehicle beam. | | | -
NOTE:Detach the instrument panel from the cross-vehicle beam to gain access to the exterior lighting control switch electrical connector. Disconnect the exterior lighting control switch electrical connector. | | | -
Remove the instrument panel. | Installation | | -
To install, reverse the removal procedure. | | |
