Five Hundred 2WD V6-3.0L VIN 1 (2006)
-
Follow each step of the procedure precisely to make sure of correct driver air bag module removal and installation.
1. Depower the system.
2. Remove the steering wheel access cover.
3. Release one side of the driver air bag module wire clip.
-
While actuating the horn at the lower part of the air bag cover, use a suitable tool (needle nose pliers, etc.) to release the wire clip until it
touches the center post.
4. Release the horn and using a suitable tool, lift the end of the wire clip over the post.
5. Release the other side of the driver air bag module wire clip.
-
While actuating the horn at the lower part of the air bag cover, use a suitable tool to release the other side of the wire clip until it touches the
center post.
