Flex AWD V6-3.5L (2009)
Trim Panel: Service and Repair
A-Pillar Trim Panel
A-Pillar Trim Panel
Removal and Installation
NOTICE: The A-pillar speaker grille is not serviceable. Do not attempt to remove the speaker grille. Failure to follow this instruction will result
in damage to the A-pillar trim panel.
1. Position aside the door opening weatherstrip.
2. Pull outward on the A-pillar trim panel to release the clips.
3. Using a flat-blade tool, remove the A-pillar trim panel tether from the body.
4. Disconnect speaker electrical connector.
5. Pull the A-pillar trim panel towards the rear of the vehicle to remove.
6. WARNING: A new A-pillar trim panel tether must be installed if the tether is damaged or does not fasten correctly. During a side air
curtain deployment the A-pillar trim panel tether helps prevent the trim from striking the occupant. Failure to follow this instruction
may result in serious injury to vehicle occupant(s).
NOTICE: Alignment tabs must be positioned properly for installation. Failure to properly align tabs may result in damage to the
component.
To install, reverse removal procedure.
