Flex FWD V6-3.5L (2010)
Power Trunk / Liftgate Control Module: Service and Repair
Liftgate/Trunk Module (LTM)
Removal and Installation
1. Remove the LH rear quarter trim panel.
2. Disconnect the Liftgate/Trunk Module (LTM) electrical connectors.
3. Remove the LTM retaining bolts and remove the LTM.
-
To install, tighten to 9 Nm (80 lb-in).
4. To install, reverse the removal procedure.
-
Initialize the power liftgate. For additional information, refer to Power Liftgate Initialization See: Service and Repair/Procedures.