Flex FWD V6-3.5L (2010)
Trunk / Liftgate Shock / Support: Service and Repair
Power Liftgate Rod
Removal and Installation
1. Remove the LH quarter trim panel access cover.
2. Unclip the power liftgate rod from the motor assembly.
-
Squeeze the clip as shown to release and position the rod assembly upward.
3. Remove the cover and the power liftgate rod-to-liftgate nut.
-
To install, apply threadlock to the threads of the fastener and tighten to 9 Nm (80 lb-in).
4. Remove the 3 power liftgate rod mounting bracket nuts.
-
To install, tighten to 9 Nm (80 lb-in).