Flex FWD V6-3.5L (2010)
5. NOTE: For retainer clarity, inside of cushion side shield shown.
Detach the cushion side shield.
1. Remove the scrivet at the rear of the cushion side shield.
2. Remove the screw at the rear of the cushion side shield.
3. Remove the screw at the front of the cushion side shield.
4. Pull out to release the clips and separate the cushion side shield.
6. If equipped, separate the wire harness pin-type retainer, disconnect the seat control switch and remove the cushion side shield.
7. If equipped, separate the manual lumbar cable.
1. Remove the pin-type retainer, release all outboard cushion trim cover J-clips and position the cushion cover up.
2. Separate the manual lumbar cable retainer.
3. Pull the manual lumbar case out of the adjuster.
8. If equipped, remove the manual lumbar cable from the adjuster.
