Flex FWD V6-3.5L (2010)
13. Remove the 2 LH recliner-to-cushion frame bolts and the LH recliner.
-
To install, tighten to 50 Nm (37 lb-ft).
Seat Recliner - Second Row, 40 Percent
Seat Recliner - Second Row, 40 Percent
Removal and Installation
WARNING: Use care when the seat back frame is removed and when releasing the recliners from a backrest upright position. The recliners are
spring-loaded, which may cause the recliner upper arms to fold with significant speed/force. Failure to follow this instruction may result in
serious personal injury.
Manual seat
1. With the backrest folded down, release the backrest trim cover lower J-clip.
2. Release the 2 backrest trim cover inside J-clips to hard back panel.
3. Roll the backrest trim cover up to access the 2 recliner-to-backrest frame bolts.
4. Release the outer and inner J-clips at the rear of the cushion trim cover.
5. Release the cushion trim cover from the flex mat.
1. Take the 4 cushion trim cover retainers out from under the second flex mat wire (1 shown).
2. Separate the 4 cushion trim cover retainers from the third flex mat wire.
6. Remove 2 screws, pull and remove the riser/seat track LH inner cover.
7. Remove 3 screws and the riser/seat track LH outer cover.
8. Remove the screw and the recliner handle.
9. Remove the screw, pull and remove the recliner outer cover.
-
On assembly, make sure the release strap is through the cover opening.
10. Remove the pin-type retainer and screw, release the locator tabs and remove the recliner inner cover.
