Flex FWD V6-3.5L (2010)
17. Roll the backrest trim cover all the way down and engage the lower J-clips.
-
If equipped, make sure the manual lumbar cable and side air bag module wire harness are routed out from the outboard side of the backrest
before engaging the lower J-clips.
-
If equipped, make sure the backrest feed wire harness is routed out from the inboard side of the backrest before engaging the lower J-clips.
18. If not equipped with a DVD player, install the 2 head restraint guides sleeves. For additional information, refer to Head Restraint Guide Sleeve
See: Head Rest/Service and Repair/Head Restraint Guide Sleeve.
19. Install the seat backrest. For additional information, refer to Seat Backrest - Front, Without Fold Flat See: Removal and Replacement/Front
Seat/Seat Backrest - Front, Without Fold Flat.
Seat Backrest - Front, With Fold Flat
Seat Backrest - Front, With Fold Flat
Disassembly
Passenger Seat Backrest With Power Seat Track
NOTE: Refer to Seat Backrest - Front, With Fold Flat See: Removal and Replacement/Front Seat/Seat Backrest - Front, With Fold Flat for recliner-to-
seat track bolt tightening sequence and torque specification.