Flex FWD V6-3.5L (2010)
11. Remove 2 screws and inner recliner cover from the inboard and outboard recliners.
12. Invert the backrest cover up and remove the first row of hog rings.
-
Route the fold-flat cable and wire harness(es) out through the backrest cover opening.
13. Invert the backrest cover up to expose the side air bag module deployment chute.
-
If equipped, feed the fold-flat cable, lumbar cable and backrest wire harness through the side openings of the backrest cover.
14. Squeeze the ends of the deployment chute clips together and open the deployment chute.
15. From the rear of the backrest, separate the backrest cover J-clip attached to the backrest frame wire.
16. Invert the backrest cover up and pull the deployment chute through the backrest foam pad.
17. Invert the backrest cover up and remove the second row of hog rings.
18. Remove the backrest cover.
19. If equipped, disconnect the backrest heated seat mat and separate the connector pin-type retainer from the backrest frame.
