Flex FWD V6-3.5L (2010)
2. If equipped, position the static lumbar and install the retainers at the bottom.
3. NOTE: Always use new clips.
If equipped, position the static lumbar behind the backrest frame wire and install 2 new retainers.
-
After installation, make sure the retainers are holding the static lumbar tightly against the backrest frame wire or squeaks can occur.
4. If equipped, install the manual lumbar.
1. Squeeze the manual lumbar retaining clips together on each side and install them to the backrest frame.
2. Route the manual lumbar cable and attach the pin-type retainer.
5. WARNING: Before installing the seat side air bag module/deployment chute assembly:
-
Inspect the side air bag module and mounting surfaces for any damage or foreign material.
-
Remove any foreign material from the mounting surfaces of the deployment chute, the seat backrest frame mounting bracket and the
air bag module cavity in the seat backrest foam pad.
-
Install new parts if damaged.
Failure to follow these instructions may result in the seat side air bag deploying incorrectly, which increases the risk of serious personal
injury or death in a crash.
NOTE: The side air bag modules are keyed left and right. If the side air bag module locator pin does not align to the backrest frame hole, the
wrong side air bag module is being installed.
Seats with heat, position the 2 side air bag module studs and locator pin through the backrest frame and install the 2 nuts.
1. Position the side air bag module and install the 2 nuts.
-
Tighten to 10 Nm (89 lb-in).
2. Route the wire harness, connect the electrical connector and attach the pin-type retainer.
