Flex FWD V6-3.5L (2010)
9. WARNING: Inspect the seat side air bag module cavity in the seat backrest foam pad for any foreign material. If any foreign material is
found, remove it. Failure to follow these instructions may result in the seat side air bag module deploying incorrectly and increases the
risk of serious personal injury or death in a crash.
Position the backrest frame assembly into the backrest foam pad.
10. If equipped, connect the backrest heated seat mat and attach the connector pin-type retainer to the backrest frame.
11. Route the fold-flat cable and DVD player wire harness (if equipped) out from between the backrest frame and backrest foam pad at the inboard
side of the backrest.
12. If equipped, route the fold-flat cable, lumbar cable and backrest feed wire harness out from between the backrest frame and backrest foam pad at
the outboard side of the backrest.
13. WARNING: Check the seat side air bag deployment chute for damage. The deployment chute must not be repaired. If there is any
damage to the deployment chute, a new seat back trim cover and deployment chute must be installed as a unit. Failure to follow these
instructions may result in the seat side air bag module deploying incorrectly and increase the risk of serious personal injury or death in a
crash.
With the backrest cover inside out, position the backrest cover to the backrest foam pad and frame assembly.
-
Align the head restraint holes in the backrest cover to the holes in the backrest foam pad and frame.
14. Roll the backrest cover down and position both ends of the deployment chute through the backrest foam pad opening.
