Flex FWD V6-3.5L (2010)
Disassembly and Assembly
NOTE: With the seat out of the vehicle and the backrest in the fold-flat position, the inboard latch foot must be in the latched position to pivot the
backrest back to the upright position.
1. Remove the seat. For additional information, refer to Seat - Second Row See: Service and Repair/Rear Seat/Seat - Second Row.
2. Remove the seat backrest. For additional information, refer to Seat Backrest - Second Row, 40 Percent See: Seat Back/Service and
Repair/Removal and Replacement/Rear Seat/Seat Backrest - Second Row, 40 Percent.
3. Remove the seat backrest recliner. For additional information, refer to Seat Recliner - Second Row, 40 Percent See: Seat Back/Service and
Repair/Removal and Replacement/Rear Seat/Seat Recliner - Second Row, 40 Percent.
4. Remove the inner pivot cover.
5. Remove the safety belt buckle bolt and safety belt buckle.
-
To install, tighten to 40 Nm (30 lb-ft).
6. Release the clip, separate the strut and the cushion trim cover hook-and-loop strips.