Flex FWD V6-3.5L (2010)
7. Release the outer and inner J-clips at the rear of the cushion trim cover.
8. From under the seat, release the cushion trim cover retainer from the outboard and inboard cushion frame.
-
Pull the inboard and outboard cushion trim cover retainers out from between the seat track and the cushion frame.
9. Invert and remove the cushion trim cover from the cushion foam pad.
-
Remove the hog rings.
10. NOTE: Always install a new cushion foam pad and new cushion heater mat together.
Remove the cushion foam pad.
-
Disconnect the cushion heater mat electrical connector and release the pin-type retainer.
-
Note the wiring harness routing for installation.
11. Remove the power-fold seat motor.
-
Remove the 2 power-fold seat motor screws.
-
Disconnect the electrical connector.
-
Detach the release cable from the cushion frame.
-
Note release cable routing for installation.
12. Remove the 6 seat track-to-cushion frame nuts.
-
To install, tighten to 23 Nm (17 lb-ft).
13. Detach the electrical connector and remove the seat track.
-
Note the cable routing for installation.
14. Remove the 2 screws and inner inboard seat track cover.
15. Remove the 2 screws and inner outboard seat track cover.
16. Remove the 3 screws and outer inboard seat track cover.
17. Remove the 3 screws and outer outboard seat track cover.
18. Release the 2 snap retainers and remove the spring assist strut.
