Flex FWD V6-3.5L (2010)
85. NOTE: RH shown, LH similar.
Position the ball joints into the wheel knuckles. Install the new ball joint nuts.
-
Tighten to 200 Nm (148 lb-ft).
86. NOTE: The hex-holding feature can be used to prevent turning of the stud while removing the nuts.
NOTE: RH shown, LH similar.
Install new tie-rod end nuts.
-
Tighten to 150 Nm (111 lb-ft).
87. NOTE: RH shown, LH similar.
Install new upper stabilizer bar link nuts.
-
Tighten to 150 Nm (111 lb-ft).
88. Install the 2 front engine roll restrictor-to-transaxle bolts.
-
Tighten to 90 Nm (66 lb-ft).
