Flex FWD V6-3.5L (2010)
6. Under the driver seat, slide and disengage the side air bag module electrical connector locking clip, release the tab and disconnect the electrical
connector.
7. Detach and position aside the D-pillar trim panels.
8. Release the pin-type retainers and position the rear portion of headliner down.
9. NOTE: LH side shown, RH similar.
Disconnect the LH side Safety Canopy(R) module electrical connector.
10. Detach and position aside the RH side D-pillar trim panel.
11. Disconnect the RH side Safety Canopy(R) module electrical connector.
12. Install the RCM fuse 32 (10A) to the SJB.
13. Connect the battery ground cable. For additional information, refer to Battery.
Reactivation
1. Turn the ignition OFF.
2. Remove the RCM fuse 32 (10A) from the SJB.
3. Disconnect the battery ground cable.
4. NOTE: LH side shown, RH side similar.
Connect the LH and RH side Safety Canopy(R) module electrical connectors.