Flex FWD V6-3.5L (2010)
Suspension Spring ( Coil / Leaf ): Overhaul
Strut and Spring Assembly
Disassembly and Assembly
WARNING: Do not apply heat or flame to the shock absorber or strut tube. The shock absorber and strut tube are gas pressurized and could
explode if heated. Failure to follow this instruction may result in serious personal injury.
WARNING: Keep all body parts clear of shock absorbers or strut rods. Shock absorbers or struts can extend unassisted. Failure to follow this
instruction may result in serious personal injury.
NOTICE: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may result
in major service expense. New parts must be installed with the same part numbers or equivalent part, if replacement is necessary. Do not use a
replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct
retention of these parts.
NOTICE: When installing a suitable spring compressor, use care not to damage the spring coating.
1. Remove the strut and spring assembly. For additional information, refer to Strut and Spring Assembly See: Suspension Strut / Shock
Absorber/Service and Repair/Removal and Replacement/Front Suspension.
2. WARNING: Do not attempt to disassemble the shock absorber and spring assembly without using a spring compressor. Assemblies are
under extreme load. Failure to follow this instruction may result in serious personal injury.
NOTE: Use the hex-holding feature to prevent the shock absorber rod from turning while removing or installing the strut rod nut.
Using a suitable spring compressor, slightly compress the spring to remove initial tension. Using the hex-holding feature to hold the strut rod,
loosen the strut rod nut. Continue to compress the spring until tension is relieved.