Flex FWD V6-3.5L (2010)
12. Remove the 2 nuts, pull the transmission fluid cooler thermal bypass valve straight up and position it aside.
13. NOTE: Note the location of the of the studbolts for assembly.
Remove the 14 bolts and the main control cover.
Installation
1. Inspect the transaxle side cover seal for damage and install new if necessary.
2. NOTICE: Inspect the 20-pin solenoid body connector seal to make sure that the seal is on the inside of the main control cover or a
transmission fluid leak will occur.
NOTE: Install the studbolts in the locations noted during disassembly.
