Flex FWD V6-3.5L (2010)
Drive/Propeller Shaft: Removal and Replacement
Driveshaft
Removal and Installation
NOTE: Index-mark both driveshaft flanges.
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove the muffler and tailpipe. For additional information, refer to Exhaust System &/or Catalytic Converter.
3. NOTE: Support the driveshaft.
Remove the 4 rear center bearing bracket outer bolts.
-
To install, tighten to 30 Nm (22 lb-ft).
4. NOTICE: Do not reuse the bolt and washer assemblies for the rear Constant Velocity (CV) joint flange. Install new assemblies or damage
to the vehicle may occur.