Focus L4-2.0L (2009)
Front Door Window Motor: Service and Repair
Window Regulator and Motor - Front Door
Window Regulator and Motor - Front Door
Removal and Installation
1. Remove the front door speaker.
2. NOTE: Do not touch the adhesive surface during removal or installation of the watershield, as re-bonding will be impaired. If additional adhesive
is required during installation, apply seam sealer as necessary to completely seal the watershield to the inner door.
Remove the watershield.
3. Temporarily install the window control switch to raise or lower the window to access the glass clamp bolts.
4. Loosen the 2 door window glass clamp bolts.
-
To install, tighten to 8 Nm (71 lb-in).
5. Tape the window in position, then lower the window regulator downward until it reaches the stops at the bottom of the regulator tracks.
6. Disconnect the window regulator motor electrical connector.
7. Remove the front 5 regulator bolts and the regulator and motor assembly.
-
To install, tighten to 8 Nm (71 lb-in).
8. To install, reverse the removal procedure.
