Focus L4-2.0L (2009)
-
To install, tighten the new nuts to 47 Nm (35 lb-ft).
2. Disconnect the hanger isolators.
6. Remove the center exhaust hanger isolator.
7. Remove the 4 nuts and the exhaust center heat shield.
8. Remove the 5 nuts and the exhaust rear heat shield from the floor panel.
9. Separate the parking brake cable from the equalizer.
10. NOTE: There are marks and sleeves on the outer cable conduit to indicate the clip locations. Note the position of the clips on the outer cable
conduit to aid installation.
Disconnect the parking brake cable from the retaining clips.
11. If equipped, remove the rear air deflectors.
-
Remove the screws.
-
Release the clip.
12. Remove the 2 parking brake cable guide bolts from the floor panel.
-
To install, tighten to 23 Nm (17 lb-ft).
13. Remove the parking brake cable from the bracket.
Rear cable
14. If equipped with ABS, remove the rear wheel speed sensor bolt and position the wheel speed sensor aside.
-
To install, tighten to 9 Nm (80 lb-in).
15. Remove the brake drum.
16. Remove the parking brake cable from the brake backing plate.
-
Pull the actuating lever forward.
-
Remove the cable from the actuating lever.
-
Compress the clip and pull the parking brake cable through the brake backing plate.
