Focus L4-2.0L (2009)
Steering Gear: Service and Repair
Steering Gear Boot
Steering Gear Boot
Removal and Installation
NOTICE: The steering gear boots and clamps are designed to produce an airtight seal and protect the internal components of the steering gear.
If the seal is not airtight, the vacuum generated during turning will draw water and contamination into the gear, causing damage. Zip ties do
not provide an airtight seal and must not be used.
NOTICE: The inner tie-rod ball joint grease is not compatible with water. Water trapped in the grease will damage the joint.
1. Remove the outer tie-rod end. For additional information, refer to Tie Rod - Outer See: Tie Rod/Service and Repair/Tie Rod - Outer.
2. Remove the tie-rod jam nut from the inner tie rod.
3. Remove the steering gear bellows boot.
1. Remove and discard the clamps.
2. Disconnect the vent tube.
3. Remove the boot.
