Ford Workshop Service and Repair Manuals

Installer, Water Seal Carrier

204-343 (14-064)

Installer, Differential Bearing

205-062 (15-025A)

Installer, ABS Sensor Ring

206-083 (12-024)

Installer, Input Shaft Seal

307-210 (17-041)

1. Remove the wheel hub.
   For additional information, refer to: Wheel Hub (204-02 Rear Suspension, Removal and Installation).
   

2. Remove and discard the wheel speed sensor ring.

3. Remove the water seal carrier (if equipped).

4. Remove the circlip.

5. Using the special tool, remove and discard the wheel bearing.

6. 

   NOTE:The following step is only required for vehicles that did not have a water seal previously installed.
   Remove and discard the wheel spindle.

1. 

   NOTE:Install a new wheel bearing.
   Using the special tool, install the wheel bearing.

2. Install the circlip.

3. Using the special tool, install the water seal carrier.

4. 

   CAUTION:Avoid any impact on the wheel speed sensor ring.
   

   CAUTION:Make sure that the wheel speed sensor ring is clean.
   

   CAUTION:Avoid any contact between the wheel speed sensor ring and a magnetic surface.
   

   NOTE:Install a new wheel speed sensor ring.
   Using the special tool, install the wheel speed sensor ring.

5. 

   NOTE:The following step is only required for vehicles that did not have a water seal previously installed.
   

   NOTE:Install a new wheel spindle.
   Install the wheel spindle.

6. Install the wheel hub.
   For additional information, refer to: Wheel Hub (204-02 Rear Suspension, Removal and Installation).