ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Clutch Pedal Position (CPP) Switch > < Cylinder Head Temperature (CHT) Sensor - 1.6L Zetec-E (Zetec)-1.8L Zetec-E (Zetec)-2.0L Zetec-E (Zetec)

Focus 1999 (08.1998-12.2004)

Electronic Engine Controls - Cylinder Head Temperature (CHT) Sensor—1.8L Diesel Focus 1999 (08/1998-12/2004)
Removal and Installation

Removal

  1. Disconnect the battery ground cable.
    For additional information, refer to: Battery Disconnect (414-01 Battery, Mounting and Cables, General Procedures).

  1. Disconnect the positive crankcase ventilation (PCV) hose.

  1. Disconnect the PCV hose.

  1. Detach the PCV oil separator.

  1. Remove the PCV oil separator.

  1. Disconnect the CHT sensor electrical connector.

  1. Remove the CHT sensor.

Installation

NOTE:
NOTE:Make sure that a new component is installed.
  1. To install, reverse the removal procedure.

  1. Initialize the door window motors.
    For additional information, refer to: Door Window Motor Initialization (501-11 Glass, Frames and Mechanisms, General Procedures).

Clutch Pedal Position (CPP) Switch > < Cylinder Head Temperature (CHT) Sensor - 1.6L Zetec-E (Zetec)-1.8L Zetec-E (Zetec)-2.0L Zetec-E (Zetec)