ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
General Procedures|Removal and Installation|Installation > < Halfshaft Seal RH

Focus 2004.75 (07.2004-)

Manual Transmission/Transaxle - Vehicles With: 6-Speed Manual Transmission (M66) - Transaxle—2.5L Duratec-ST (VI5) Focus 2004.75 (07/2004-)

Removal

Special Tool(s)
303-290-01
Adapter for 303-290A

303-290-02
Adapter for 303-290A

303-290-03A
Adapter for 303-290A

303-290A
Support Bar, Engine
General Equipment
Transmission jack
  1. Refer to: Health and Safety Precautions (100-00 General Information, Description and Operation).
  1. Remove the air cleaner.
    Refer to: Air Cleaner - Vehicles With: PCM Security Shield (303-12B Intake Air Distribution and Filtering - 2.5L Duratec-ST (VI5), Removal and Installation).
    Refer to: Air Cleaner - Vehicles Without: PCM Security Shield (303-12B Intake Air Distribution and Filtering - 2.5L Duratec-ST (VI5), Removal and Installation).

  1. Remove the air cowl grille.
    Refer to: Cowl Panel Grille (501-02 Front End Body Panels, Removal and Installation).
  1. Remove the battery carrier.
    Refer to: Battery Tray - 2.5L Duratec-ST (VI5) (414-01 Battery, Mounting and Cables, Removal and Installation).

  1. Detach the starter motor from the transmission and secure it to one side.

  1. CAUTION:
    CAUTION:Make sure that all openings are sealed.

  1. NOTE:
    NOTE:The flexible exhaust pipe must not be twisted.

  1. Remove the axle shafts.
    Refer to: Rechte Antriebswelle (205-04 Vorderradantriebswellen, Removal and Installation).
    Refer to: Front Halfshaft LH (205-04 Front Drive Halfshafts, Removal and Installation).

  1. Special Tool(s): 303-290-02, 303-290-03A, 303-290A

  1. Discard the bolt on the rear engine mounting.

  1. Wooden block (approx. 300 mm long).

  1. Support the transmission using wooden blocks.
    General Equipment: Transmission jack

  1. Rotate the transmission approximately 30° counter-clockwise during removal.
    General Equipment: Transmission jack

General Procedures|Removal and Installation|Installation > < Halfshaft Seal RH