Ford Focus RS 2003 Workshop Service and Repair Manuals

Installer, Differential Bearing

205-062 (15-025A)

Installer, Input Shaft Seal

307-210 (17-041)

1. Remove the wheel hub.
   For additional information, refer to Wheel Hub in this section.
   

2. Remove and discard the wheel speed sensor ring.

3. Remove and discard the wheel speed sensor ring adapter.

4. Remove the circlip.

5. Using the special tool, remove the wheel bearing.

1. 

   CAUTION:Support the brake disc on the wheel mounting face and not on the wheel nut studs.
   Using the special tool, install the new wheel bearing.

2. Install the circlip.

3. 

   CAUTION:Make sure the wheel speed sensor ring adapter is clean.
   

   CAUTION:Do not apply excessive force when installing the wheel speed sensor ring adapter.
   Install a new wheel speed sensor ring adapter.

4. 

   CAUTION:Avoid any impact on the wheel speed sensor ring.
   

   CAUTION:Make sure the wheel speed sensor ring is clean.
   

   CAUTION:Avoid any contact between the wheel speed sensor ring and a magnetic surface.
   Install a new wheel speed sensor ring.

5. Install the wheel hub.
   For additional information, refer to Wheel Hub in this section.