ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Rear Wheel Speed Sensor > < Anti-Lock Brake System (ABS) Module - 2.0L Duratec-RS (Zetec) RHD

Focus RS 2003 (09.2002-)

Anti-Lock Control - Anti-Lock Brake System (ABS) Module—2.0L Duratec-RS (Zetec) LHD Focus RS 2003 (09/2002-)
Removal and Installation

Materials
Name
Specification
Super DOT 4 Brake Fluid
ESD-M6C57-A 

Removal

CAUTION:
CAUTION:If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water.
  1. Disconnect the battery ground cable. For additional information, refer to Section  414-01 Battery, Mounting and Cables.

  1. Disconnect the low brake fluid warning indicator switch electrical connector.
    1. Pull back the tab.
    1. Depress the clips.
    1. Disconnect the electrical connector.

  1. CAUTION:
    CAUTION:The brake fluid reservoir cap must not become contaminated.
    Remove the brake fluid reservoir cap.

  1. NOTE:
    NOTE:It will be necessary to carry out this step on both sides in order to completely drain the brake fluid reservoir.
    Drain the brake fluid reservoir.
    1. Connect one end of a suitable piece of clear plastic pipe to the bleed nipple and place the other end into a suitable container.
    1. Loosen the bleed nipple.
    1. Depress the brake pedal until all the fluid is drained from the brake fluid reservoir.
    1. Tighten the bleed nipple.
  1. Install the brake fluid reservoir cap.
  1. Remove the charge air cooler. For additional information, refer to Section  303-12 Intake Air Distribution and Filtering.

  1. Remove the charge air cooler outlet hose.

  1. Disconnect the battery junction box (BJB) electrical connectors.

  1. Remove the BJB retaining screw.

  1. Detach the BJB from the BJB support bracket and position it to one side.
    • Depress the locking tangs.

  1. Disconnect the anti-lock brake system (ABS) module electrical connector.
    1. Release the retainer.
    1. Disconnect the electrical connector.

  1. CAUTION:
    CAUTION:Cap the brake tubes to prevent fluid loss or dirt ingress.
    NOTE:
    NOTE:Make a note of the position of the brake tubes, to aid installation.
    Disconnect the brake tubes from the hydraulic control unit (HCU).

  1. Detach the brake tubes from the bulkhead.

  1. CAUTION:
    CAUTION:Cap the brake tubes to prevent fluid loss or dirt ingress.
    Remove the brake master cylinder to HCU brake tubes.

  1. Detach the HCU and ABS module assembly from the support bracket.

  1. Remove the ABS module to HCU retaining bolts.
  1. Remove the ABS module.

Installation

  1. To install, reverse the removal procedure.
  1. Bleed the brake system. For additional information, refer to Section  206-00 Brake System - General Information.

Rear Wheel Speed Sensor > < Anti-Lock Brake System (ABS) Module - 2.0L Duratec-RS (Zetec) RHD