ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Rear Window Glass - 2.0L Duratec-RS (Zetec) > < Door Window Motor Initialization

Focus RS 2003 (09.2002-)

Glass, Frames and Mechanisms - Front Door Window Glass—2.0L Duratec-RS (Zetec) Focus RS 2003 (09/2002-)
Removal and Installation

Removal

  1. Remove the front door trim panel. For additional information, refer to Section  501-05 Interior Trim and Ornamentation.

  1. Remove the side impact bolster.

  1. Detach the speaker from the front door panel.

  1. Remove the speaker.
    • Disconnect the electrical connector.

  1. Detach the door latch release handle from the front door panel.

  1. CAUTION:
    CAUTION:Do not touch the adhesive surface as re-bonding will be impaired.
    Detach the watershield from the front door panel.

  1. Detach the window one-touch down relay from the front door panel.

  1. Connect the power window control switch electrical connector.

  1. Remove the front door window glass clamp bolts.
    • Align the retaining bolts with the access holes.

  1. Detach the front door window glass from the regulator.
    1. Hold the front door window glass at the top of the opening.
    1. Lower the regulator.

  1. NOTE:
    NOTE:The front door window glass must be removed towards the outside of the window opening.
    Remove the front door window glass.
    1. Lift the glass.
    1. Tip the glass forwards and remove the glass from the front door.

Installation

  1. NOTE:
    NOTE:The front door window glass must be installed towards the outside of the window opening.
    To install, reverse the removal procedure.

Rear Window Glass - 2.0L Duratec-RS (Zetec) > < Door Window Motor Initialization