Removal and Installation Removal | -
WARNING:Always wear safety glasses when working on an air bag equipped vehicle and when handling an air bag module. Failure to follow this instruction may result in personal injury. | | -
Detach the instrument panel lower panel. - Remove the screws.
- Detach the clip.
| | -
Remove the instrument panel lower panel. - Disconnect the data link connector (DLC) .
- Disconnect the footwell light electrical connector (if equipped) .
| | -
Remove the steering column upper shroud. - Using a thin bladed screwdriver, release the two clips (one each side).
| | -
Detach the audio control switch from the steering column lower shroud (if equipped). - Using a thin bladed screwdriver, release the locking tang.
| | -
Remove the audio control switch (if equipped). - Disconnect the electrical connector.
| | -
Remove the steering column lower shroud. - Release the steering column locking lever.
- Remove the screws.
| | -
Detach and lower the steering column. - Remove and discard the nuts.
| | -
Remove the audio unit. For additional information, refer to Section 415-01 Audio Unit. | | -
Remove the glove compartment. | | -
Detach the climate control and audio unit trim panel from the instrument panel. - Remove the screws.
- Detach the clips.
| | -
Remove the climate control and audio unit trim panel. - Disconnect the electrical connectors.
- Disconnect the climate control cables.
| | -
Remove the heater core housing assembly panel. - Remove the screws (left-hand side shown).
| | -
Remove the insert from the front of the floor console. | | -
Remove the floor console front retaining screws. | | -
Remove the floor console rear retaining screw. - Remove the screw cover.
- Remove the screw.
| | -
Move the floor console rearwards. | | -
Remove the instrument panel upper retaining clips. - Install a M6 x 100 mm bolt.
- Using a suitable tool, remove the retaining clips.
| | -
Remove the instrument panel side trim panels. | | -
Remove the instrument panel side bolts (left-hand side shown). | | -
Detach the instrument panel. - Detach the defroster tubes.
| | -
Remove the instrument panel. | Installation | -
WARNING:When installing the steering column, make sure new nuts are installed. Failure to follow this instruction may result in personal injury. To install, reverse the removal procedure. | | |