ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
501-20A Safety Belt System > < Front Bumper Cover - 2.0L Duratec-RS (Zetec)

Focus RS 2003 (09.2002-)

Bumpers - Rear Bumper Cover—2.0L Duratec-RS (Zetec) Focus RS 2003 (09/2002-)
Removal and Installation

Removal
  1. Remove the upper pushpin retainers.
  1. Raise and support the vehicle. For additional information, refer to Section  100-02 Jacking and Lifting.

  1. Remove the lower pushpin retainers.

  1. Detach the bumper cover from the fender splash shield on both sides.

  1. Detach the bumper cover from the fender on both sides.
    • Remove the retaining bolt.
  1. Lower the vehicle.

  1. CAUTION:
    CAUTION:The bumper cover ends must be pulled away from the fenders to prevent damage to the paintwork.
    NOTE:
    NOTE:With the aid of another technician, support the bumper cover.
    Detach the bumper cover from the fenders.
    1. Detach the clips.
    1. Disconnect the fog lamp and reversing lamp electrical connectors.
  1. Remove the bumper cover.

Installation

  1. To install, reverse the removal procedure.

501-20A Safety Belt System > < Front Bumper Cover - 2.0L Duratec-RS (Zetec)