Focus ZTS L4-2.0L DOHC VIN 3 (2001)
2. Slide a suitable tool under the boot seat to allow the air to escape.
3. Locate the boot in position and remove the suitable tool.
2. NOTE: Install new clamping straps.
Using the special tool install the clamping straps in the boot ring grooves.
3. Install the boot at the transaxle end.
^
Insert the clamping strap in the boot ring groove and tighten it using the special tool.
4. CAUTION: Do not damage the universal joint rollers.
Install the tripod.
^
Using the special tool, push the tripod onto the front drive halfshaft as far as it will go.
5. NOTE: Install a new snap ring.
