Fusion FWD L4-2.3L VIN Z (2007)
Remove the 2 brake caliper guide pin bolts and position the caliper aside.
^
Support the caliper using mechanic's wire.
4. Remove the 2 brake pads, shims and slide clips. Inspect the brake pads for wear or contamination.
^
Inspect the brake pads for wear and contamination.
5. Remove the 2 brake caliper anchor plate bolts and the anchor plate.
Installation
1. Install the brake caliper anchor plate and the 2 brake caliper anchor plate bolts.
^
Tighten to 70 Nm (52 ft. lbs.).
2. Install the 2 brake pads and slide clips to the brake caliper anchor plate.
3. NOTE: Make sure that the brake caliper hose is not twisted.
Position the brake caliper on the anchor plate and install the 2 guide pin bolts.
^
Tighten to 26 Nm (19 ft. lbs.).
4. Install the parking brake cable to the brake caliper.
^
Pull back the parking brake lever.
^
Connect the cable to the parking brake lever.
^
Install the cable conduit retaining clip.
5. Cycle the park brake several times to verify normal operation.
6. Test the brakes for normal operation.