Fusion FWD L4-2.3L VIN Z (2007)
^
Install a new crankshaft pulley bolt. Using the special tools to hold the crankshaft pulley in place, tighten the crankshaft pulley bolt in 2 stages:
^
Stage 1: Tighten to 100 Nm (74 ft. lbs.).
^
Stage 2: Tighten an additional 90 degrees (1/4 turn).
5. Remove the 6 mm (0.23 inch) x 18 mm (0.7 inch) bolt.
6. Remove the special tool.
7. Remove the special tool.
8. NOTE: Only turn the engine in the normal direction of rotation.
Turn the crankshaft clockwise 1 and 3/4 turns.
9. Install the special tool.
