ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 8368 > < Initial Inspection and Diagnostic Overview
Page 2
background image

-

SETUP

-

RESET

Information Displays (INFO button)

The information displays are non-timed modes. The selected mode remains on until the driver presses a message center button to change the mode or
it is overridden by another mode. The information display modes are:
-

Odometer

-

Trip odometer A or B

-

Distance to empty (DTE)

-

Average fuel economy

-

Average speed

-

Compass (if equipped)

-

Trip elapsed drive time

Setup Displays (SETUP button)

The setup displays are timed modes and terminate after a finite interval. The setup display modes are:
-

System check

-

NOTE:  Pressing the message center switch SETUP button, the message center displays the current units to be displayed. Refer to the Owner's
Literature for more information.

Units (English/metric)

-

Language

System Check Messages (RESET button)

By pressing the RESET button on the message center switch, the message center cycles through each of the system check messages being monitored.
For each of the monitored systems, the message center indicates either an OK message or a warning message for 2-4 seconds.

The system check messages are:
-

DOORS CLOSED

-

ENGINE TEMPERATURE

-

CHARGING SYSTEM

-

OIL PRESSURE

-

BRAKE FLUID LEVEL

-

EXTERIOR LAMPS

-

FUEL LEVEL

-

DISTANCE TO EMPTY (DTE)

System Warning Messages

System warnings alert the operator to possible problems or malfunctions in the vehicle operating system. When multiple warnings are displayed, the
message center cycles all the warnings by displaying each one for several seconds.

The message center displays the last selected feature if there are no more warning messages. This allows full functionality of the message center by
pressing the message center switch RESET button to clear the warning message. Warning messages that have been reset are divided into 3 categories
where the message:
-

does not disappear until a condition has changed.

-

will reappear 10 minutes after pressing the RESET button.

-

does not reappear until the ignition switch LOCK/OFF to RUN cycle has been completed. This acts as a reminder that the warning conditions still
exist on the vehicle.

The system warning messages that cannot be reset are:
-

DRIVER DOOR AJAR

-

PASSENGER DOOR AJAR

-

REAR LEFT DOOR AJAR

-

REAR RIGHT DOOR AJAR

-

PARK BRAKE ENGAGED

The system warning messages that return after 10 minutes are:
-

LOW FUEL LEVEL

-

CHECK CHARGING SYSTEM

-

CHECK BRAKE SYSTEM

The system warning messages that return after the ignition switch is turned from the LOCK/OFF to RUN position are:
-

LOW BRAKE FLUID LEVEL

-

TRUNK AJAR

Initial Inspection and Diagnostic Overview|Page 8368 > < Initial Inspection and Diagnostic Overview