Fusion FWD L4-2.3L VIN Z (2007)
8. Position a suitable floor jack under the transaxle.
9. Remove the remaining 4 transaxle rear support insulator bolts.
-
If the mount studs are removed or come out, do not reinstall the old stud. Install a new stud. Make sure the stud is properly seated in the case.
-
To install, tighten to 63 Nm (46 ft. lbs.).
10. Remove the clutch hydraulic line spring clip. Push downward on the clutch line to release it from the bracket.
11. Remove the clutch hydraulic line plastic retainer.
