Fusion FWD L4-2.5L Hybrid (2010)
Apply a 2.5 mm (0.09 in) bead of silicone gasket and sealant to the cylinder head and oil pan joint areas. Apply a 2.5 mm (0.09 in) bead of silicone
gasket and sealant to the front cover.
3. Install the engine front cover. Tighten the bolts in the sequence shown, to the following specifications:
-
Tighten the 8-mm bolts to 10 Nm (89 lb-in).
-
Tighten the 13-mm bolts to 48 Nm (35 lb-ft).
4. Connect the vehicle high voltage electrical connector to the DC/DC converter and attach the wiring retainer.
5. Install the A/C tube bracket bolt to the strut tower.
-
Tighten to 6 Nm (53 lb-in).
6. NOTE: Remove the through bolt from the Camshaft Front Oil Seal Installer.
NOTE: Lubricate the oil seal with clean engine oil.
Using the Camshaft Front Oil Seal Installer, install the crankshaft front seal.
7. Install the coolant pump pulley and the 3 bolts.
-
Tighten to 20 Nm (177 lb-in).
